Gedik · Low-alloy steels

ER 110 SG G 69 5 MIG — ER110S-G
Technical datasheet · solid wire · Ø 1 – 1.2 mm
FT-ER-110-SG-G-69-5-MIG-EN
rev. 2 · 2026-11-21
page 1 / 2
rev. 2 · 2026-11-21
page 1 / 2
Type
solid wire
Standard
ER110S-G
Diameters
Ø 1 – 1.2 mm
Application
- ER 110 SG is low alloyed and high strength GMAW wire and GTAW rods
- It is used for joining of the high strength low alloy steels and the fine grained constructional steels with minimum yield strength of 690 N/mm2, especially Hardox and Weldox sheets
- Boilers, pressure vessels, pipelines, structure steels are the other application areas
- Weld metal has high impact and toughness at low temperatures
- Pre-heat can be according to the base material
- Shielding gases - MAG: (Ar+% 15-25 CO2) / TIG: (Ar)
Classification
AWS class
ER110S-G
EN ISO class
G 69 5 M21 Mn3Ni1CrMo
Chemical composition of the wire
C
Cr
Cu
Mn
Mo
Ni
Si
0.12
0.30
0.35
1.70
0.30
1.40
0.50
Values in mass %.
Base metals
S690Q · L690M · N-A-XTRA 70 · USS-T1 · BH 70 V · HY 100 · ASTM A514 Gr.F
Mechanical properties
Yield strength (Rp0.2)
min. 690 MPa
Tensile strength (Rm)
770–940 MPa
Elongation (A5)
min. 17 %
Impact energy (KV)
min. 47 J (−50 °C)
Process
Polarity
DC+
Shielding gas
Ar + 15–25% CO2
Positions
PA flat · PB horizontal-vertical · PC horizontal · PD horizontal-overhead · PE overhead · PF vertical-up
Shielding
Requires shielding gas
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-ER-110-SG-G-69-5-MIG-EN · rev. 2 · page 1 / 2
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Gedik 2023 catalogue