Dratec · Low-alloy steels

DT-MF 15 FCW — E110T15-M21A8-K4-H4
Technical datasheet · flux-cored wire (FCW) · Ø 1.2 – 1.6 mm
FT-DT-MF-15-FCW-EN
rev. 2 · 2026-11-21
page 1 / 1
rev. 2 · 2026-11-21
page 1 / 1
Type
flux-cored wire (FCW)
Standard
E110T15-M21A8-K4-H4
Diameters
Ø 1.2 – 1.6 mm
Sizes and packaging
Ø
Code
1.2 mm
DRT-1807-12
1.6 mm
DRT-1807-16
Supply programme: spools on request D100 (0.5–1 kg), D200 (2–5 kg), K300 (15–20 kg)
Application
Metal powder cored wire without slag. Suitable for the spatter-free welding of fine-grain structural steels where a high tensile strength is required (e.g. crane and plant construction); very good welding properties, therefore particularly suitable for robot applications (good arc restriking); recovery >93 %
Classification
AWS class
E110T15-M21A8-K4-H4
EN ISO class
T69 6 Mn2NiCrMo MM 1H5
Chemical composition of the wire
C
Cr
Mn
Mo
Ni
Si
0.07
0.50
1.50
0.40
2.20
0.40
Values in mass %.
Base metals
NA-X-TRA 55–70 · Weldox 700 · S690QL1
Mechanical properties
guide values
Yield strength (Rp0.2)
> 690 MPa
Tensile strength (Rm)
> 760 MPa
Elongation (A5)
> 15 %
Impact energy (KV)
60 J
Process
Polarity
DC+
Shielding gas
M2
Positions
PA flat · PB horizontal-vertical · PC horizontal · PD horizontal-overhead · PE overhead · PF vertical-up · PG vertical-down
Shielding
Requires shielding gas
Recovery
> 93 %
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-DT-MF-15-FCW-EN · rev. 2 · page 1 / 1
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Dratec 2025 catalogue