Download PDF
← Technical datasheet
Dratec · Hardfacing
FERVEO

DT-DUR 65 FCW — T Fe 16

Technical datasheet · flux-cored wire (FCW) · Ø 1.6 – 2.8 mm
FT-DT-DUR-65-FCW-EN
rev. 2 · 2026-11-21
page 1 / 1
Type
flux-cored wire (FCW)
Standard
T Fe 16
Diameters
Ø 1.6 – 2.8 mm
Sizes and packaging
Ø
Current
Voltage
Packaging
Code
1.6 mm
160–260 A
20–26 V
K300 15–20 kg
DRT-1585-16
2.8 mm
320–400 A
25–28 V
K300 15–20 kg
DRT-1585-28
Application

DT-DUR 65 is a flux-cored wire with a high C, Cr, Mo, Nb, W and V content. Owing to the high percentage of alloying constituents, which form extremely hard carbides, DT-DUR 65 is suitable for hard overlays on parts subject to extreme abrasive mineral wear. The wear resistance is retained at temperatures up to approx. 800 °C. The microstructure consists of Cr carbides of primary and eutectic solidification as well as Nb, Mo, W and V carbides in a heat- and scale-resistant austenitic matrix. The hardness decreases at 400 °C by about 4 % and at 700 °C by about 10 %. Blast furnace bells, fire grates, spiked crushers

Classification
EN 14700 class
T Fe 16
DIN 8555 class
MF 10 - 65 - G Z
Chemical composition of the wire
C
V
W
Cr
Mn
Mo
Nb
Si
5.20
1.00
2.00
21.0
0.40
7.00
7.00
1.00
Values in mass %.
Hardness
guide values
63–65 HRC
QR code for the current version of this datasheet
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-DT-DUR-65-FCW-EN · rev. 2 · page 1 / 1

Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.

Prepared by FERVEO from the Dratec 2025 catalogue