
DT-DUR 55Mo FCW — T Z Fe 14
rev. 2 · 2026-11-21
page 1 / 1
DT-DUR 55 Mo is a self-shielded flux-cored wire highly alloyed with C, Cr and Mo. It is suitable for surfacing parts exposed to severe wear by mineral materials. The weld metal is rust-resistant. Surfacing should be carried out in 2-3 layers with a maximum thickness of 8 mm. The best results are obtained with a two-layer weld. The weld metal should be subjected only to limited shock and impact. With a small wire diameter and an ideal current setting, crack-free surfacing is possible. The addition of 1.3 % molybdenum also gives the deposit a higher strength at high temperatures than the alloy DT-DUR 55 (up to 450 °C). Grinding bowls, crushing rolls
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Dratec 2025 catalogue