Dratec · Copper, brasses and bronzes

DT-CuSi 3 MIG — ER CuSi-A
Technical datasheet · solid wire · Ø 0.8 – 1.6 mm
FT-DT-CUSI-3-MIG-EN
rev. 2 · 2026-11-21
page 1 / 2
rev. 2 · 2026-11-21
page 1 / 2
Type
solid wire
Standard
ER CuSi-A
Diameters
Ø 0.8 – 1.6 mm
Sizes and packaging
Ø
Packaging
Code
0.8 mm
K300 15–20 kg
DRT-1790-08
1 mm
K300 15–20 kg
DRT-1790-10
1.2 mm
K300 15–20 kg
DRT-1790-12
1.6 mm
K300 15–20 kg
DRT-1790-16
Indicative diameters; confirmed with the order
Supply programme: spools on request D100 (0.5–1 kg), D200 (2–5 kg)
Application
Joint welding of copper, copper-zinc alloys; surfacing on cast iron, as well as on unalloyed and low-alloy steels; MIG brazing of galvanised steel sheets, as well as of higher-strength sheets
Classification
AWS class
ER CuSi-A
EN ISO class
S Cu 6560 (CuSi3Mn1)
Chemical composition of the wire
Cu
Fe
Mn
Si
Sn
Zn
balance
0.07
1.00
3.00
0.10
0.10
Values in mass %.
Mechanical properties
guide values
Yield strength (Rp0.2)
150 MPa
Tensile strength (Rm)
390 MPa
Elongation (A5)
40 %
Impact energy (KV)
60 J
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-DT-CUSI-3-MIG-EN · rev. 2 · page 1 / 2
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Dratec 2025 catalogue