Download PDF
← Technical datasheet
Gedik · Hardfacing
FERVEO

250 G MIG

Technical datasheet · solid wire · Ø 1.2 mm
FT-250-G-MIG-EN
rev. 2 · 2026-11-21
page 1 / 1
Type
solid wire
Diameters
Ø 1.2 mm
Sizes and packaging
Ø
Packaging
Code
1.2 mm
BS 300 spool
GDK-6031100313
Application
  • Cr-Mo alloyed steels (1.5%-0.5%) resistant to high temperature, wear, pressure and shocks
  • Good resistance to cracking and to the attack of sulphurous agents
  • Guide rollers, excavators, screw conveyers, gears, moulds, rolling surfaces, etc
  • Before the application of welding, it is recommended pre-heating of 300°C
  • If necessary, post-weld stress relief should be made at 690°C
  • Shielding Gas: Ar+CO2 mix gases can be used
Classification
DIN 8555 class
MSG 1-GZ-250
Approvals

SEPRO

Validity is confirmed with the order

Chemical composition of the wire
C
Cr
Mn
Mo
Si
0.09
3.00
1.00
1.00
0.55
Values in mass %.
Hardness
Hardness after work hardening
22–27 HRC
Process
Polarity
DC+
Shielding gas
Ar + CO2
Shielding
Requires shielding gas
Treatment and preparation
Pre-heating
300 °C
Post-weld heat treatment
690 °C, if necessary
QR code for the current version of this datasheet
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-250-G-MIG-EN · rev. 2 · page 1 / 1

Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.

Prepared by FERVEO from the Gedik 2023 catalogue