Gedik · Tool steels

TOOL 58 SG TIG
Technical datasheet · TIG rod · Ø 1.6 – 2.4 mm
FT-TOOL-58-SG-TIG-EN
rev. 2 · 2026-11-21
page 1 / 1
rev. 2 · 2026-11-21
page 1 / 1
Type
TIG rod
Diameters
Ø 1.6 – 2.4 mm
Sizes and packaging
Ø
Length
Packaging
Code
1.6 mm
1000 mm
5 kg
GDK-6031100359
2 mm
1000 mm
5 kg
GDK-6031100360
2.4 mm
1000 mm
5 kg
GDK-6031100153
Application
- High adhesive wear and impact-resistant, cold work tool steels require filling from strength, high temperature, abrasion and impact resistance that requires welding of hot-work tool steels are used
- The construction of non-alloy steel cutting edge, cutting and stripping tool steels used in the regions
- Tool steels can be given 300°C to 400°C pre-heating source
- Shielding Gas: MAG: Ar+CO2 mix gases TIG: Ar
Classification
DIN 8555 class
M / WSG 3-GZ-60-T
Approvals
SEPRO
Validity is confirmed with the order
Chemical composition of the wire
C
V
W
Cr
Mn
Mo
Si
0.37
0.35
1.30
5.20
0.40
1.40
1.10
Values in mass %.
Hardness
as welded
57–60 HRC
Process
Polarity
DC−
Shielding gas
Ar
Shielding
Requires shielding gas
Treatment and preparation
Pre-heating
300–400 °C, can be applied
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-TOOL-58-SG-TIG-EN · rev. 2 · page 1 / 1
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Gedik 2023 catalogue