Gedik · Tool steels

HARDCOR KST 55 FCW — T Z Fe 3
Technical datasheet · flux-cored wire (FCW) · Ø 1.2 mm
FT-HARDCOR-KST-55-FCW-EN
rev. 2 · 2026-11-21
page 1 / 1
rev. 2 · 2026-11-21
page 1 / 1
Type
flux-cored wire (FCW)
Standard
T Z Fe 3
Diameters
Ø 1.2 mm
Sizes and packaging
Ø
Current
Voltage
Stick-out
Packaging
Code
1.2 mm
150–220 A
26–30 V
20–25 mm
15 kg
GDK-3030500410
Application
- Metal type flux-cored wire. Used for repairing hot and cold work tools. Machinability is very good.
- HARDCOR KST 55 is a metal type flux-cored wire which wear resistant alloy and can be applied to reclaim hot-forging dies.
- It can be applied to overlay the edges and flat areas of low alloyed high density steel tools.
- It is used in the repair of equipment that is subject to high wear such as buckets, excavators, crushers used in the mining industry.
- Shielding Gas: M21
Classification
EN 14700 class
T Z Fe 3
DIN 8555 class
MF 3-GF-55-ST
Chemical composition of the weld metal
C
V
W
Cr
Mn
0.30
0.40
4.50
3.80
0.28
Values in mass %.
Hardness
as welded
52–57 HRC
Process
Polarity
DC+
Shielding gas
M21
Shielding
Requires shielding gas
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-HARDCOR-KST-55-FCW-EN · rev. 2 · page 1 / 1
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Gedik 2023 catalogue