Gedik · Tool steels

ELHARD 40 W — E Fe 1
Technical datasheet · covered electrode · stick electrode · Ø 3.2 – 4 mm
FT-ELHARD-40-W-EN
rev. 2 · 2026-11-21
page 1 / 1
rev. 2 · 2026-11-21
page 1 / 1
Type
covered electrode · stick electrode
Standard
E Fe 1
Diameters
Ø 3.2 – 4 mm
Sizes and packaging
Ø
Length
Current
Code
3.2 mm
350 mm
100–140 A
GDK-3010101906
4 mm
350 mm
140–180 A
GDK-3010101909
Application
- For build-up of dies made of hot-work tool steels and for surfacing where thermal shock resistance is required
- Preheating and slow cooling must be applied, depending on the parent material
- The weld metal retains its hardness up to 500 °C
- Soft annealing can be applied for easier machining
- Redrying of the electrodes before use at 300 °C to 350 °C for at least 2 h is recommended
Classification
EN 14700 class
E Fe 1
DIN 8555 class
E 3-UM-400-GPTS
Approvals
SEPRO
Validity is confirmed with the order
Chemical composition of the weld metal
C
V
W
Cr
Mn
Mo
Si
0.20
0.40
0.50
3.20
1.10
0.60
0.80
Values in mass %.
Hardness
380–440 HB
Process
Polarity
DC+
Treatment and preparation
Re-drying
300–350 °C / 2 h
Pre-heating
according to the base material
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-ELHARD-40-W-EN · rev. 2 · page 1 / 1
Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.
Prepared by FERVEO from the Gedik 2023 catalogue