Download PDF
← Technical datasheet
Gedik · Hardfacing
FERVEO

500 G TIG — S Fe 2

Technical datasheet · TIG rod · Ø 2 mm
FT-500-G-TIG-EN
rev. 2 · 2026-11-21
page 1 / 1
Type
TIG rod
Standard
S Fe 2
Diameters
Ø 2 mm
Sizes and packaging
Ø
Length
Packaging
Code
2 mm
1000 mm
carton box
GDK-6031100316
Application
  • Excellent resistance to wear and shocks
  • Parts of excavators, mordan bucket teeth, drilling and percussion bits, shaping machines, screw conveyors, crushers, moulds, guide rollers, etc
  • Before the application of welding, it is recommended pre-heating of 300°C
  • If necessary, post-weld stress relief should be made at 690°C
  • Shielding Gas: MAG; Ar+CO2 mix gases & TIG; % 100 Ar gas can be used
Classification
EN 14700 class
S Fe 2
DIN 8555 class
MSG / WSG 2-GZ-50
Approvals

SEPRO

Validity is confirmed with the order

Chemical composition of the wire
C
Cr
Mn
Si
Ti
1.10
1.80
1.90
0.50
0.20
Values in mass %.
Hardness
Hardness after work hardening
47–52 HRC
Process
Polarity
DC−
Shielding gas
100% Ar
Shielding
Requires shielding gas
Treatment and preparation
Pre-heating
300 °C
Post-weld heat treatment
690 °C, if necessary
QR code for the current version of this datasheet
FERVEO IBERICA, S.L.U. · NIF B05613559 · Avda. del Tomillar, 70, 29631 Benalmádena (Málaga) · Registered in the Registro Mercantil de Málaga, sheet MA-201214 · info@ferveo.eu · www.ferveo.eu · FT-500-G-TIG-EN · rev. 2 · page 1 / 1

Typical values, not guaranteed: this document is not a declaration of performance and does not replace the manufacturer's official documentation or the applicable WPS.

Prepared by FERVEO from the Gedik 2023 catalogue