We open on 1 January 2027. Until then we are not accepting registrations or requests.
Datasheetas published in the maker's catalogueCross-referencesacross makers and AWS / EN ISO classesDeliverySpain and PortugalESPTEN
FERVEO
Basket

Calculators

Fillet weld throat and leg

Convert throat a to leg z and back, check the code minimums, see the weld to scale and in 3D, and take the size to the consumption calculator.

Fillet weld · T-joint

Size on the drawing
Height of the inscribed triangle to the theoretical root (EN ISO 2553).
Plates
Volume

ResultEN ISO 5817 · C

a 5 mm · z 7.1 mm

L = 10 m

Face width w
10 mm
Max. excess weld metal h (503)
2.5 mm
Section A (flat – max.)
50.0–83.3 mm²
Weld volume
500–833 cm³
Deposited metal
3.93–6.54 kg
  • a ≥ 3 mm — minimum for load-bearing welds (EN 1993-1-8, 4.5.2(2)).
  • Plates 4 mm or thicker (EN 1993-1-8, 4.1).
Calculate filler consumption →

Section · to scale (ISO 129-1)

Section · to scale (ISO 129-1)a 5z₁ 7.1z₂ 7.1t₁ 12t₂ 10

True dimensions. Excess weld metal is drawn at the level maximum; the dashed line is the flat weld.

On the drawing · EN ISO 2553

On the drawing · EN ISO 2553a5a5

Both sides: symbol above and below the reference line.

On the drawing: a5.

Isometric view · ISO 5456-3

Isometric view of the fillet weldtravelL = 10 mV 500–833 cm³Isometric view of the fillet weldtravelL = 10 mV 500–833 cm³

Representative length: section to scale, length shortened. Volume and mass are for the real L.

Penetration shown on the cut end is indicative and not part of the calculation.

Basis: EN ISO 2553 (symbols), EN 1993-1-8 (minimums), EN ISO 5817 (excess weld metal 503). Always check against your drawing and WPS.

← All calculators